Skip Navigation

VideoEdge™ 4 Channel IP Encoder v1.02 Upgrade

This software is used to upgrade VideoEdge™ 4 Channel IP Encoder units. Please read carefully the following important information before attempting to upgrade your encoder. For detailed descriptions of the new features in this upgrade, refer to the Release Notes.

Features

VideoEdge 4 Channel IP encoder v1.02 upgrade provides several new features which include:

  • Deinterlacing filter - an image processing technique that performs frame to frame analysis for motion detection, and corrects the jagged motion edges into continuous data stream. This new feature is included to improve the video data display of motion at high resolution encoder settings.
  • Encoder localization into English, French, German, Portuguese and Spanish.
  • Improvements in access of camera controls and camera communication protocols.

Download and Installation Instructions

  • For upgrading and operating instructions, please refer to the VideoEdge™ 4 Channel IP Encoder User Guide.
  • In order to achieve optimal system performance, it is highly recommended that the Intellex IP connected to the encoder is running the latest Intellex IP software, v4.17.

Download Instructions:

  1. On a PC equipped with a removable media, download and save the software below to your local hard drive and/or laptop or PC directly connected to the IP Encoder

Installation Instructions:

Note: Performing this upgrade will result in all saved configuration settings being removed and the IP Encoder will be restored to the default factory settings (including the IP address, username and password). It is therefore important to back up the configuration data file prior to upgrade, and then restore the configuration after the upgrade has been completed.

To Back Up Current Encoder Configuration Note

Note: If the IP Encoder subnet has been changed form the default settings, then the configuration backup and firmware upgrade procedures should be completed using a laptop or PC directly connected to the IP Encoder.

  1. From the encoder Front page, select Backup Config
  2. Select Save from the pop up dialog box
  3. Select the appropriate location and enter a file name for the configuration file. Then select Save.


    4. Note: The file name must end in ADIPE4.txt.

To Install the New Firmware

  1. From the encoder Main Configuration page, select Update Firmware.
  2. Enter the name of the FUP (including network path) to be used, or select Browse and use the file browser to locate and select the FUP.
  3. Select Update Firmware.
  4. Select Restart to restart the IP Encoder and complete the update procedure.

To Restore the Backup Configuration from the Data File

Note: Once the factory default settings are restored on the IP Encoder the IP address will be reset to 192.168.1.80. The laptop or PC connected to the IP Encoder must be reconfigured to the same subnet in order to restore the saved configuration settings.

  1. From encoder Main Configuration page, select Restore Config.
  2. Enter the name of the backup file (including network path) to be used, or select Browse and use the file browser to locate and select the backup file.
  3. Select Load File.
  4. Verify the new configuration settings are correct.
  5. From the encoder Main Configuration page, select Save Config.
Filename Size Date
ADIPE4_0312-4001_V1.02.1056.zip 1.62 MB Mar-14-2008